Programming Lenze Drive 9300 Series Main, Aux and Pick Up G2G3G4 by Keypad

1. Press Program key
2. Press Left Arrow(user mode) key
3. Press Up Arrow (code list) key
4. Press Right Arrow(enter) key
5. Use Up and Down Arrow keys to see different parameters
6. To change parameters first go to parameter no. C002
7. Initially the C002 parameter is always 1. if we want to change the parameters, then first we have to make C002 as 0 otherwise it does not allow to change parameters.
8. But be careful because once we make C002 as 0, all the parameters in the drive goes to factory set values. i.e. default values
9. Then go to the parameters we want to change as per our requirement (press “Shift + Program” key for fast switching between parameters)
10. Press Program key to set new value( set new values using Up and Down Arrow keys)
11. To save the new value press “Shift + Program” key, then OK message appears on the display.
12. Again press program key to return to last menu
13. After changing all  parameters, go to C003 parameter
14. Make C003 parameter as 1 to save and load all changes we made.