| TO TAKE BACKUP FROM LENZE DRIVE TO LAPTOP |
| |
| 1 | Connect LECOM to drive and RS232 cable to Laptop |
| 2 | Connect 24 Vdc supply to connector no. 39(-) and 59(+) |
| 3 | Open GDC ( Global Drive Controller) software from desktop |
| 4 | It starts searching, 'IF not' Press F4 and then F2, select search |
| 5 | Automatically reading parameter from drive |
| 6 | Short commissioning 93XX window open |
| 7 | Select code list |
| 8 | Select Drive parameters and select write all parameters set to "File" |
| 9 | Type file name e.g. 05ngr1.GDC and check the saving path. |
| 10 | Press OK |
| 11 | Select F4 before quit the program GDC |
| 12 | Please check saved file in saving path positon. |
| |
| TO TAKE BACKUP OF LENZE DRIVE AT FOLDER A AND B |
| |
| 1 | Put jumper in 2 and 3 then connect LECOM |
| 2 | Follow above 1 to 12 steps |
| |
| TO TAKE BACKUP FROM LAPTOP TO LENZE DRIVE |
| |
| 1 | Connect LECOM to drive and RS232 cable to Laptop |
| 2 | Connect 24 Vdc supply to connector no. 39(-) and 59(+) |
| 3 | Open GDC ( Global Drive Controller) software from desktop |
| 4 | It starts searching, 'IF not' Press F4 and then F2, select search |
| 5 | Automatically reading parameter from drive |
| 6 | Short commissioning 93XX window open |
| 7 | Select Drive parameters and select read all parameter set from file |
| 8 | Read parameter set from file window open, select the file to be load, press OK |
| 9 | GDC warning window open, Press Yes, Code list display on window |
| 10 | Select drive parameters and select write all parameter set to drive |
| 11 | Warning parameter set transfer window open, Press OK |
| 12 | Transfer variant selection-parameter set to drive window open |
| Press exchange unit |
| 13 | Parametersatztransfer window open |
| 14 | Start writing parameter to drive, after finish |
| 15 | Press F4 |
| 16 | Close GDC |
| 17 | OFF/ON the power of drive |
| |
| UPLOAD AND DOWNLOAD PARAMETER FROM 2 IN 1 PLC TO PC |
| |
| 1 | Connect 24 VDC supply to connector no. 3(-) and 2(+) |
| 2 | Connect cable to RS232 and PC |
| 3 | Choose program PVI |
| 4 | Transfer pvi file |
| 5 | Select execute. |
| 6 | Downloading starts |
| 7 | Finish successfully |
| 8 | Path D:mullermartini\_mm software 2009\2 in 1\2 in 1 transfer |
| |
