Downloading Software to PanelWare(PW) of Muller Martini

1. Remove cable from port-2
2. Connect RS-232 cable to laptop
3. Open Download Tool software (installed in the laptop)
4. Click on OPEN PROJECT option and select “NGR3_PW.dip” file and press OK
5. Path for NGR3_PW.dip file:- C:\Daten\MMVZ\DLT\CFG
6. Computer will ask for drive 1/4
7. Insert floppy disk 1/4 and press OK and wait for next message
8. Again Computer will ask to load disk 2/4.
9. Insert floppy disk 2/4 and press OK and wait for the next message
10. Message-switch off the panel, (disconnect the power supply)
11. Message-connect the RS-232 cable to port-0 of the panel(connect the cable to port-0)
12. Message-turn mode switch of the panel to position-6(turn mode switch to position-6 from original position-5)
13. Message- switch on the panel(connect the power supply)
14. Message-reset the panel(press reset button on the panel)
15. New window appears on the screen and it showing

Try connection…….

Start download …… (0%....97%)

(Window will close automatically after download finish)

 wait for the next message

16. Message-turn mode switch to position-7( turn mode switch to position-7)
17. Press OK.
18. Message-press reset button at panel( press reset button and press OK)
19. New window “Project Wizard” appears on the screen           
20. In project wizard window select the Application download option and press START button.
21. New window “State Window” appears on the screen and it will confirm some actions.
• check cable connected (recheck and press OK)
• check mode position-7 (recheck and press OK)
• check press reset button at panel (if reset button was pressed in step no-17 then no need to press it again, press OK)
22. Communication between computer and panelware starts
23. Downloading starts.
24. Wait for 10-20 minutes and next message
25. Message-Turn Mode Switch to position-5( turn switch to position-5 & press OK)
26. Message-Press Reset button( Press reset button & press OK)
27. Green message comes on the Download tool window-it means download application finished successfully.
28. Then disconnect power and connect port-2 cable and connect power again
29. Restart the whole system.
30. Software installation Finished.