Download:-From Card to Drive
- Switch Off power
- Take out interbus module and connect lenze card
module
- It shows 0 at the start
- Select number for particular drive by pressing T3
button on the card module
- 3-Infeed Drive
6. Yellow and Green
LED glows-it means parameter set matches for that Drive
7. To start
download program from card to drive-push T1 button and hold for 3
seconds
8. Display starts
counting from 9 to 0
9. Push T1
again
10. LED starts blinking- it means download starts
11. After some time LED is idle-it means download
finished
12. Switch Off power and take out Lenze card
module and connect interbus module
13. Switch ON
14. Check in software version on HMI. It should be as
follows:
Core
1 – 135.5
Core
2 – 135.5
In
feed – 121
Arm
- 311
Upload:-From Drive to Card
1. Switch Off power
2. Take out interbus module, Remove write
protection of the card and connect lenze card module.
3. Switch ON power
4. It shows 0 at the start
5. Select Empty data set by pressing T3 button
on the card module,( here 4-9 are empty data sets, so select any one of them.)
- 4- for Core Drive 1
- 5- for Core Drive 2
- 6-for Infeed Drive
6. To start upload program from drive to
card-push T2 and hold for 3 seconds
7. LED starts blinking- it means upload starts
8. After some time
LED is idle-it means upload finished
9. Switch Off
power and take out Lenze card module and connect interbus module
10. Switch ON