Downlaod:-From Card to Drive
- Switch Off power
- Take out interbus module and connect lenze card module
- It shows 0 at the start
5
Yellow and Green LED glows-it means parameter set
matches for that Drive
6
To start download program from card to drive-push T1
button until 9 display (hold for 3 seconds)
7
Display starts counting from 9 to 0
8
Display show 0 means procedure finished.
9
Check in software version on HMI. It should be as
follows:
Core 1 – 135.5
Core 2 – 135.5
In feed – 121
Arm - 311
Upload:-From Drive to Card
1 Switch
Off power
2 Take
out interbus module, Remove write protection of the card and connect lenze
card module.
3 Switch
ON power
4 It
shows 0 at the start
5 Select Empty data set by pressing T3 button on the
card module,( here 4-9 are empty data sets, so select any one of them.)
- 4- for Core Drive 1
- 5- for Core Drive 2
- 6-for Infeed Drive
6 To
start upload program from drive to card-push T2 and hold for 3 seconds
7 LED
starts blinking- it means upload starts
8 After
some time LED is idle-it means upload finished
9 Switch
Off power and take out Lenze card module and connect interbus module
10 Switch ON power