0424 C166 timeout occurred during LT reset
0442 Synchronous motor has no position of rest
0447 Error on writing the stop angle
0448 Error while checking the stop position
0449 Error stop position outside the tolerance range
0450 Error absolute interface not ready for stop angle run
0452 Imr controller limit (ID 490) > 80% I_LT_Nom
0453 No ready for service at run stop position
0454 Motor temperature invalid for ASM slip characteristic line, less than -50°C or higher than 200 °C
0455 Stop angle run for ASM motor
0456 Nominal field current is too large for synchronous motor
0457 Nominal field current is too small for asynchronous motor
0458 Error occurred with motor identification
0500 Leading axle interconnection missing drives
0501 Leading axle interconnection missing drives
0503 Too many clients
0504 SERCOS: More drives found than are configured
0505 SERCOS: Less drives found than are configured
0506 External drive found with the same address as an internal drive
0507 More ISR subscribers found than configured
0508 Less ISR subscribers found than configured
0509 External ISR subscribers found with the same address as internal ISR subscribers
0510 Protocol change
0511 No cross-communication set up
0514 Section overreach without cross-communication
0540 BA_POSIT_2 Internal w2 too large